5438时钟配置.docVIP

5438时钟配置 //****************************************************************************** // MSP430F543xA Demo - XT2 sources MCLK SMCLK // // Description: This program demonstrates using XT2 to source MCLK. XT1 is not // connected in this case. // // By default, LFXT1 is requested by the following modules: // - FLL // - ACLK // If LFXT1 is NOT used and if the user does not change the source modules, // it causes the XT1xxOFIFG flag to be set because it is constantly looking // for LFXT1. OFIFG, global oscillator fault flag, will always be set if LFXT1 // is set. Hence, it is important to ensure LFXT1 is no longer being sourced // if LFXT1 is NOT used. // MCLK = XT2 // PMMCOREV = 2 to support up to 20MHz clock // // NOTE: if the SMCLK/HF XTAL frequency exceeds 8MHz, VCore must be set // accordingly to support the system speed. Refer to MSP430x5xx Family Users Guide // Section 2.2 for more information. // // MSP430F5438A // ----------------- // /|\ | | // | | | // ---|RST | // | XT2IN|- // | | HF XTAL (455kHz - 16MHz) // | XT2OUT|- // | | // | P11.1|-- MCLK = XT2 // | P11.2|-- SMCLK = XT2 // // Note: // In order to run the system at up to 20MHz, VCore must be set at 1.8V // or higher. This is done by invoking function SetVCore(), which requires // 2 files, hal_pmm.c and hal_pmm.h, to be included in the project. // hal_pmm.c and hal_pmm.h are located in the same folder as the code // example. // // D. Dang // Texas Instruments Inc. // December 2009 // Built with CCS Version: 4.0.2 and IAR Embedded Workbench Version: 4.21.8 //****************************************************************************** #include msp430x54xA.h #include hal_pmm.h void main(void) { WDTCTL = WDTPW + WDTHOLD;