起重机吊车维修方案（Maintenance plan for crane）..docVIP

起重机吊车维修方案（Maintenance plan for crane） Serial parts name big repair project technical standard 1 crane Hook (1) disassemble, inspect hooks, shafts, beams, pulleys, bearings, and clean and lubricate (2) inspect the worn condition of dangerous section (3) the test of the hook (4) hook plate repair (1) hook, cross beam, a pulley shaft, no crack, the threaded part should not loose, bearing intact, rotating pulley, a knife or crack thread groove should be replaced. (2) replacement of dangerous section wear over 10% of original height shall be replaced. (3) after the overhaul, the hook shall be tested and checked. The suspension shall be suspended for 10 minutes at 1.25 times the rated load, and the elastic opening of the hook shall not exceed 0.25% of the size of the hook. No permanent deformation or crack shall be caused after unloading; (4) the gap between the plate and the plate shall not be greater than 0.3mm after the riveting of the plate hook 2 steel silk Rope (1) broken wire inspection; (2) radial wear (3) deformation inspection; (4) wire rope lubrication (1) the number of broken wires in the 1 twist intervals exceeds 10% of the total number of steel wires, and should be scrapped as standard (2) when the radial wear of steel wire exceeds 40% of the original diameter, the whole steel wire rope should be scrapped (3) the diameter of the wire rope is reduced to 70% of the rope diameter; the rope core is exposed and the broken stock should be scrapped to replace the new steel wire rope (4) before lubrication, brush with wire brush, kerosene and so on. Use wire rope hemp grease (Q/SY1152-65) or synthetic graphite calcium base lubrication finger (SYA1405-65), dip coating saturation is appropriate 3. round group (1) and maintenance of pulley block, check crack (2) maintenance of pulley groove; (3) inspection of axle hole; (4) assembly (1) pulley shaft shall not have cracks, shaft neck shall not wear, the original diameter of 30%, the cone is not greater than 5%, more tha