高密度聚乙烯双壁波纹管管道设计、施工技术规程..docVIP

高密度聚乙烯双壁波纹管管道设计、施工技术规程 In order to measure the capacity of pipe to withstand external pressure, there is no physical meaning. 3.05, elastic diameter deformation rate elastic, diameter, deformation, rate The ratio between the limit value of the elastic deformation in the vertical direction of pipe diameter and the central diameter of pipe before loading 4.1 pipe pipe quality of 4 materials used in 4.1.1 design, should comply with national standards and industry standards. With the quality inspection department of product certification and product performance specifications, and should be marked with the manufacturer, specifications and production date. The nominal diameter Di pipeline, the minimum average diameter of Di, according to the stipulations of table 4.1.1-1; ring stiffness see table 4.1.1-2 grade; pressure rating table 4.1.1-3. HDPE double wall corrugated pipe specification sheet ring stiffness classification (KN/m2) table 4.1.1-2 level ring stiffness S1 = 4, S2 = 8 S3 = 16, S4 = 32 (mm) 4.1.1-1 mm) 4.1.1- Internal pressure grade classification (Mpa) table 4.1.1-3 level P1 P2 P3 The physical and mechanical properties of 4.1.2 pipes shall comply with the following provisions: density: 950kg/m3 ~ 970kg/m3: = 800MPa; elastic modulus; tensile yield strength is not less than 20MPa; the minimum internal pressure 4.1.3 pressure drainage pipe should be not less than 0.2MPa. but gravity flow pipeline as a closed water test under the condition of 23 DEG C when the requirement is not less than 1.5m head. 4.1.4 pipe ring stiffness, should be selected according to the stress conditions of loading pipe subjected to external pressure. Generally the ring stiffness of the pipe should be greater than or equal to the 4KN/m2. design institute or the use of the unit to the company for HDPE. The list selection conditions of pipeline section characteristics of 4.1.5 pipeline, should be calculated according to the section size of production factory. 4.1.6 appearance quality of pip