高强度钢的裁减率对於BA退火後显微组织及机械性质的影响-YOKE.PDFVIP

高強度鋼的裁減率對於高強度鋼的裁減率對於 BA退火後顯微組織及機械性質的影響退火後顯微組織及機械性質的影響 高強度鋼的裁減率對於高強度鋼的裁減率對於 退火後顯微組織及機械性質的影響退火後顯微組織及機械性質的影響 Effects of Cold Rolling Reduction on Microstructure and Mechanical Properties of High Strength Steel after Batch Annealing 許開揚 a 劉育佐b 蔡明欽c,* a b c,* Kai Yang Hsu , Yu Tso Liu , Ming-Chin Tsai a University of Washington, Department of Material Science and Engineering, Seattle, Washington, United States b University of Washington, Department of Applied and Computational Math Sciences, Seattle, Washinton, United States c,*China Steel Corporation, Steel Product Development Section, Iron and Steel Research and Development Department, Kaohsiung, Taiwan, ROC 摘要摘要 drawing. In order to find the best r-value on high 摘要摘要 一般高強度鋼的延展性及深衝性會隨著 strength steel, steel at different cold reduction 強度增加而下降，然而冷軋裁減率的變化卻可 with the same annealing condition will be used to compare their microstructures using optical 能導入不同退火再結晶能，而使得特定的條件 microscopy and mechanical property using 下獲得強度與成形性兼顧之鋼材。因此本論文 tensile test. This paper shows that the 使用不同裁減率 40%-70% 來研究其對於封盒 microstructure and mechanical properties after 退火 (BA)後顯微組織及機械性質的影響。利用 batch annealing using different cold rolling 光學顯微鏡觀察顯微組織的變化和拉伸試驗 reductions of 40-70%. The microstructures are 測試不同機械性質的影響，發現深衝性指標 r