单片机LED和数字温度计.docVIP

Y N 设置完成 N Y N N N Y N Y N N Y N Y N 中断程序 #includereg52.h #define uchar unsigned char #define uint unsigned int sbit beep = P3^7 ; sbit RST = P3^4 ; sbit SCK = P3^5 ; sbit io = P3^6 ; sbit key1 = P1^0 ; sbit key2 = P1^1 ; sbit key3 = P1^2 ; sbit key4 = P1^3 ; uchar i,j,mod,flag ; uchar code LED[10] ={0xC0,0xF9,0xA4,0xB0,0x99,0x92,0x82,0xF8,0x80,0x90,}; uchar disbuf[8] ={ 0x62,0xa2,0xf7,0x7a,0x28,0xf7,0x7e,0x7e }; struct time { uchar second ; uchar minute ; uchar hour ; uchar day ; uchar month ; uchar year ; } current_time ; #define ctime current_time //延时程序： void delay(int n) { unsigned int i,j; for(i=0;in;i++) { for(j=0;j121;j++) {;} } } //滴一声，用来按键伴音 void di() { uchar i ; for(i=0;i40;i++) { beep = 0 ; delay(1) ; beep = 1 ; delay(1) ; } } //滴滴，连续响两下。用来报时提醒。 void didi() { uchar i ; for(i = 2; i0; i--) { di(); delay(140); } }//DS1302的写驱动，传入参数为一个地址和数据 void write(uchar addr,uchar dat) { uchar i ; RST = 0 ; SCK = 0 ; RST = 1 ; for(i=0;i8;i++) { SCK = 0 ; io = (bit)(addr0x01) ; addr =1 ; SCK = 1 ; } for(i=0;i8;i++) { SCK = 0 ; io = (bit)(dat0x01); dat = 1 ; SCK = 1 ; } RST = 0 ; } //DS1302的读驱动，传入参数为一个地址，返回参数为读到的数据 uchar read(uchar addr) { uchar i,dat ; RST = 0 ; SCK = 0 ; RST = 1 ; for(i=0;i8;i++) { SCK = 0 ; io =(bit)(addr0x01); addr=1 ; S