减少测量误差影响的误差检测–K值控制法-控制理论与应用.PDFVIP

30 5 Vol. 30 No. 5 2013 5 Control Theory Applications May 2013 DOI: 10.7641/CTA.2013.21026 – , ( , 510640) : , ; , . , , . , , , , . , , . – : ; ; ; ; : TM77 : A Error-detection--control for reducing effects from measurement errors TIAN Xin-liang, YANG Ping (Clean Energy Technology Lab, School of Electric Power, South China University of Technology, Guangzhou Guangdong 510640, China) Abstract: In this approach, the error signal and the output signal of a single closed-loop system or a multiple closed-loop system, and a compound system of multiple-object and multiple-control with weak coupling are detected to obtain the expected output signal , and then we replace with the new expected output which equals plus times and perform the control with original algorithm. Comparing this control with the traditional control in which we obtain by detecting and , we find the effect from measurement errors on system errors are reduced. Meanwhile, it makes possible to change the open-loop gain of individual controlled object by adjusting the coefficient to achieve the optimization for the open-loop gain of individual controlled object, thus cutting down the adjusting and testing work and reducing the steady-state errors of the system. The effect from the measurement error on the original control system is derived analytically, and the principle of lowering effect from measurement errors is explained. An application of this approach to active filters is investigated, and the efficacy of this schem