基于计算机界面控制的数字量输入输出结构板的研制本科毕设.docVIP

基于计算机界面控制的数字量 输入/输出结构板的研制 DI、DO Development Based on Computer Interface 摘 要 本是STC12C5A08S2单片机，研制的可编程序控制器系统，及基于计算机界面控制的DI(Digital Input）、DO(Digital Output)MCGS((Monitor and Control Generated System)画面，经处理后，由数字量输出控制。 硬件部分由程序下载口，状态显示，复位，信息通信等几部分组成，软件部分采用由MODBUS通信协议，CRC校验，数据传送等部分组成，实现可编程控制器的DI、DODI、DOSTC12C5A08S2单片机；DI；DO；MCGS组态软件 ABSTRACT This issue is based on the STC12C5A08S2 microcontroller, the development of a domestic Programmable Logic Controller DI (Digital Input), DO (Digital Output) module, and computer interface control system. The module is controlled using two-way STC12C5A08S2 I/O port, in order to achieve digital input and output functions. The computer interface module can receive information on ladder frame, ladder executable by compiling information, and the results returned to the screen. Meanwhile, outside the module can also be uploaded to the configuration of digital information MCGS ((Monitor and Control Generated System) screen, after treatment, the digital output control. The hardware part of the program downloaded from the port, status display, reset, and information communications of several components, software components used by the MODBUS communication protocol, CRC checking, the watchdog process, data transmission and other components, to achieve programmable controller DI, DO module internal procedures, and computer-based control interface, DI, DO module internal procedures. This design tasks is to learn to complete the circuit board hardware design, learning and debugging software programs. This device is a studio teacher, I use all the results of Song made, all hardware circuit and software test and correct by the actual project for those who are interested in imitation. Key Words：STC12C5A08S2 microcontroller; DI; DO; MCGS control system ; 目 录 第一章 引 言 6 第二章 数字量输入（DI）模块 8 2.1数字量输入(Digital Input，DI)部分工作原理 8 2.1.1输入板下层板原理图 9 2.1.2 输入板下层板原件清单 11 2.1.3输入板下层板工作原理 12 2.2数字量输入(Digital Input，DI)上层板模块 13 2.2.1输入板上层板原理图 15 2.2.2输入板上层