仪表放大器设计指南第三版06.pdfVIP

Chapter-6: IN-AMP AND DIFF AMP APPLICATIONS CIRCUITS 第六第六章章：：仪表放大器与差分放大器应用电路仪表放大器与差分放大器应用电路 第第六六章章：：仪表放大器与差分放大器应用电路仪表放大器与差分放大器应用电路 A True Differential Output In-Amp Circuit 真差分输出仪表放大器电路真差分输出仪表放大器电路 真差分输出仪表放大器电路真差分输出仪表放大器电路 The AD8222 can be easily configured as a true differential output in-amp, as shown in Figure 6-1. Note that this connection provides a low impedance output at both +OUT and –OUT. AD8222 可以非常容易的配置成一个真差分输出的仪表放大器，如图 6-1。注意，该电路的两个输 出端 +OUT、-OUT 均为低阻输出。 Because the differential voltage is set solely by Amplifier A1, all of the precision specifications (offset voltage, offset drift, and 1/f noise) are the same as if Amplifier A1 were operating in single-ended mode. 因为差模电压由放大器 A1 唯一确定，所有精度指标（失调电压、失调漂移、1/f 噪声）均与放大 器 A1 工作在单端模式下相同。 Amplifier A1 sets the differential output voltage by maintaining the following equation: 放大器 A1 的差摸输出电压设定遵循下方程： V = V − V = (V − V )× Gain DIFFOUT + OUT − OUT + IN − IN A1 The output common-mode voltage is set by the average of VREF2 voltage and VREF1. Amplifier A2 sets the output common-mode voltage by maintaining the following equation: 输出共模电压有参考电压 VREAF1、VREF2 的算术平均值确定。放大器 A2 输出共模电压遵循下述 方程： V + V V + V V = + OUT − OUT = REF 1 REF 2 CMOUT 2 2 Because the VREF1 and VREF2 pins have different properties, the reference voltage may be easily set for a wide variety of applications. Note that VREF2 is high impedance but cannot swing to the supply rails of the part. In contrast, VREF1 must be driven with a low impedance but can go 300 mV beyond the supply rails. One very common application sets the common-mode out