Part 8 - Spectral Fatigue SACST 培训教材.pdf

Part 8 -Spectral Fatigue Preparation 1) Under “Training Project”, create “Spectral Fatigue” subdirectory 2) Under “Spectral Fatigue”, Create “Foundation SE”, “Modes” and “Fatigue” subdirectories. 3) Copy SACINP.STA model file, SEAINP.STA Seastate file and PSIINP.DAT soil data from “\Spectral Earthquake\Static SE” directory to “Foundation SE” directory. 4) Copy SEAINP.DYN from “\Spectral Earthquake\Modes” directory to “Modes” directory Creating foundation superelement under “Foundation SE” directory, 1) Modifying Model file SACINP.STA for creating foundation superelement suitable for wave response analysis Live weight factor in weight combination MASS shall be modified from 0.75 to 1.0. 2) Modifying Seastate file SEAINP.STA for create foundation superelement suitable for wave response analysis Delete load conditions GRVX and GRVY; Add two new load conditions named as X000 and Y090, wave loads will be generated for 1.5 m wave height at 4.42 sec wave period for both 000 and 090 directions respectively. Stream function will be used for calculating wave force in 18 steps, maximum base shear will be selected for critical position. Weight selection lines INCWGT used to select weight groups ANOD and WKWY for possible wave forces. Delete load combination EQKS. Combine load combinations SUPX and SUPY with X000 and Y090 correspondingly. Modify LCSEL line to only include SUPX and SUPY load combinations. Part of Seastate input file defined shall looks like following: LDOPT NF+Z 1.025 7.85 -79.50 79.50 MN NPNP K LCSEL SUPX SUPY … LOAD LOADCNDEAD INCWGT ANODWKWY DEAD DEAD -Z