AD7746 Code精选.pdfVIP

//====================================================================== // // Author : // // Date : Sep 2006 // // File : i2c.c // // Description : use the i2c function for MicroConverter(ADuC812) DEMO // to control the CDC AD7746 // // // (1)use tmr2 in timer function to transmit CDC result in 1Hz; // (2)setup CDCs mode refers to AD7746EVBs software setup // // Reference : ADuC812s example asm-code i2cmstr.asm // Technical Note ： uC001 - MicroConverter I2C Compatible Interface //====================================================================== #include stdio.h #include ADuC812.h #define SLAVEADD 0x90 #define CDC_RESET_ADDR 0xBF #define CDC_CAPDATA_ADDR 0x01 sbit LED = P3^4; sbit RDY = P3^5; volatile unsigned char I2C_Flag=0; //bit0:ERR //bit1:NOACK #define ERR 0 #define NOACK 1 //Cap result unsigned char CapResult_H,CapResult_M,CapResult_L; //////////////////////////////////////////////////////////////////// void UART_Init() { TMOD = 0x20; //9600 baud assuming 11.0592MHz crystal TH1 = 0xFD; TL1 = 0xFD; SCON = 0x52; TR1 = 1; } //HEX2ASCII : converts ch into the hex character representing the value of chs //least significant nibble unsigned char HEX2ASCII(unsigned char ch) { ch = 0x0F; if(ch=0x0A) ch += 7; ch += 0; return ch; } void UART_sendchar(unsigned char c) { while(!TI); TI = 0; SBUF = c; } //UART_SendVar : converts the hex value of ch into two ASCII chars, and then spits //these two characters up the UART. void UART_SendVar(unsigned char ch) { unsigned char ch_temp = ch; ch_temp = 4; ch_temp = HEX2ASCII(ch_temp); UART_sendchar(ch_temp); ch = HEX2ASCII(ch); UART_sendchar(ch); }