摆动剪切机构设计.docVIP

摆动剪切机构设计 摘要 摆动剪切机是安装在型钢热连机前，用于切头切尾和卡钢事故的处理剪。随着国民经济的发展，对型钢产品数量的要求更高。本设计为型钢设计切头的摆动剪，设计中对摆动剪的局部做了改进。 的概况进行了整体的介绍。在、产品质量理论上应该有一定的提高。 全套CAD图纸等，联系A Design of Swing Scissors Abstract Swing scissors is installed before the sharp steel of hot continuous rolling mills, which is used to cut the head and end of the steel and deal with the jamming of the steels.With the development of the national economy, the request of the sharp steels’s quality is higher than before. In the thesis, the cutting of the head of the swing scissors is researched, and makes some improvments of partial strcture. First, the thesis has discussed the position of the rolling mill of sharp steel in the national economy, and makes the general instruction for 300/500 unit plane arrangement. Next, introducing the structural characteristic of the swing cutting and the method and content of the research .According to exising equipment condition, analysing the exist problem in equipment production, the strcture of the major parts are reasonable to choosed. Then,according to the primitive parameter of the unit, I primarily choose the capacity of the main motor, and make the heat examination and overload examination, choose if satisfying the requirement, otherwise choose again until the examination is satisfyed. I make the strength examination for major element. As to gears, I make the strength calulation; as to crank, I caculated the curving stress and the crooked synthesis stress, examinationing the dangerous cross section, as well as the improment of the damages of the slide and the method of lubrication. Finally I caculated the economy appraisal and the reliablity of swing scissors. Through the work of this thesis, swing scissors should certain raise in service life and product quality theoretically, but need the unceasing improvement in practice. Key-word: scissors, swing, main drive 目录 1 绪论 1 1.1 课题选择的背景和目的 1 1.2 热轧型钢轧机的国内外发展趋势 1 1.2.1 轧机布置向半连续化或全连续化发展 2 1.2.2 轧制工艺改革出现了切分轧制、热轧冷拔 2 1.2.3 轧机结构改造 提高轧制速度 2 1