卷取温度对低碳钢组织性能及AIN 析出行为的影晌(AlN)精选.pdf

第 32 卷第6 期 北京科技大学学报 Vo l. 32 No.6 2010 年 6 月 Journal of University of Science and Technology Beijing Jun. 2010 卷取温度对低碳钢组织性能及 AIN 析出行为的影晌 王 岩1) 赵爱民1) 陈银莉1) 左碧强1) 薛俊平2) 1) 北京科技大学冶金工程研究院，北京 100083 2) 首钢技术研究院，北京 100041 摘 要 运用拉伸、金相、析出物定量分析、TEM 和 EDS 等测试方法，对不同卷取温度低碳钢组织性能及析出进行研究结果 表明:随着卷取温度的升高，钢的强度和晶粒度等级下降，固海的 N 含量逐渐降低，740C卷取时固溶的 N 含量几乎为零.热力 学和动力学分析表明，AlN 主要是在卷取过程中产生的透射电镜观察到的 AlN 尺寸在 10-50nm ，并且具有复杂的化学成 分. 关键词 低碳钢;卷取温度; AlN; 析出 分类号 TG335.3 Effect of coiling temperature on the AIN precipitation , microstructure and me- chanical properties of low carbon steel l 2 WANG yαn， ) , ZHAO Ai-min ) , CHEN Yin-li ) , ZUO Bi-qiαπgl) , XUE Jun-ping ) 1) Metallurgical Engineering Research Institute , University of Science and Technology Beijing , Beijing 100083 , China 2) Research Institute of Technology , Shougang Group Corporation , Beijing 100041 , China ABSTRACT The precipitation , microstructure and mechanical properties of low carbon steel at different coiling temperatures were in- vestigated by tensile testing , metallography , quantitative analysis of precipitates , TEM and EDS. The results show that with the coiling temperature increasing , the strength and grain size grade of the steel and the content of nitrogen in solution decrease gradually; at a coi- ling temperature of 740 C, the content of nitrogen in solution is almost zero. Thermodynamic and kinetic analyses indicate that AlN precipitates in coiling chiefly. The sizes of AlN , with complex chemical composition , are between 10 nm and 50 nm KEY WORDS low carbon steel; coiling temperature; AlN; precipitation 用透射电子显微