2002款欧宝威达VECTRA-C转向及悬挂技术培训.pptVIP

04 Steering Suspension EHPS III - Vectra-C - Multi-speed - High-speed CAN, vehicle interface - 600W hydraulic power - Lower current consumption (85A max.) - Synthetic oil Pentosin CHF 11S (1940700 Dexron II) ABS AHL ? Suspension Alloy steering knuckle TPMS: Activated as of IG ON Sensor active as of ±30 km/h Only pressure measurement* Brake pedal signal for chassis movement 433.92 MHz (Europe) or 315 MHz (Japan/ Australia) “Battery low state” below 2.4V ? DTC Warning as of -0,3 bar Alarm as of -0,6 bar Spare wheel without sensor ? DTC Tech 2 Pressure Programming, depends on: - Engine - Tire size CAN-low - BCM - REC Questions? 05 Brakes BASF Hydraulan 404 - Optimised viscosity at low temperatures 135 mm3/s at -25°C (used to be 240 mm3/s) 660 mm3/s at -40°C (used to be 1400 mm3/s) CIM ABS YRS EHPS Intentional steering direction Grip on surface Braking power Cornering Brake Control: - Lateral acceleration calculated Wheel speeds FL/FR RL/RR Vehicle speed - Cornering situation identified Braking - Brake pressure on inner front wheel limited/reduced - No ABS pump triggering ESP ESP+ How can you identify ABS, TC, ESP…? Prevent further brake pressure increasement Return brake fluid to LPA Connect master cylinder to pump, to increase pressure (TC/ESP) Detect driver’s braking requirement Isolate connection between pump and master cylinder Questions? Thank you very much for your attention! * *