大众奥迪W12 6.0L发动机技术培训.pptVIP

Service schedules Replace spark plugs Note: When removing the side part of the intake pipe, it must be ensured that the threaded sleeve for bolt 1 is secured against falling out. Service schedules Oil change Dry-sump lubrication The oil must be changed via drain plugs 1 / 2 / 3 and cannot be extracted by suction. Tightening torque Nm Oil filter cover 25 Oil drain plug on oil filter housing 10 Oil drain plug on engine 55 Oil drain plug on reservoir 25 Oil grade The 6.0l W12 engine must only be filled with LongLife oil. VW Standard 503 01. 1 3 Service schedules Check oil level Important For accurate determination of oil level in the W 12 engine, the instructions below must be followed. Otherwise, incorrect measurements will result. - Oil temperature: 80° C (VAS 5051) - Allow engine to idle - Switch off engine - Determine oil level within 2 minutes Service schedules Oil dipstick Marked fields on oil dipstick Marked fields on oil dipstick max: MIN Max Min a b c Z Oil dipstick 07C 115 611 H Application with oil reservoir assembly 07C 115 373 G Max Min a b c Service schedules Headlights: check settings and adjust if necessary Test conditions Tyre pressures OK Lenses clean and OK Reflectors and bulbs OK Vehicle loading according to specifications: 75 kg on drivers seat Tank at least 90% full; otherwise an additional weight must be placed in the luggage compartment Vehicle tool kit as well as spare wheel in place Gas-discharge headlight: Allow engine to idle. Select system using VAS 5051 Address word 55 Interrogate fault memory / erase fault memory Initiate basic setting (function 04) Select display group number 001 and confirm with Q key Adjust left headlight. Press arrow key Initiate basic setting (function 04) Select display group number 002 and confirm with Q key Press arrow key / select end of output with 06 Control of the injection and ignition systems is via two engine control u