1-2、cisco网络设备互联.pptVIP

IP地址配置的基本原则 路由器的物理网络端口需要有一个IP地址 相邻路由器的相邻端口IP地址在同一网段 同一路由器不同端口在不同网段上(牢记！) IP协议配置的主要任务 配置端口IP地址 　　　IP ADDRESS 本端口IP地址 子网掩码 配置广域网线路协议 配置IP地址与物理网络地址如何映射 配置路由 其它设置 小结： CISCO路由器配置途径有几种控制方式？ CISCO有几种配置模式？ * * Slide 1 of 1 Purpose: Emphasize: When you exit the setup mode, the configuration can be saved to RAM and NVRAM at the same time. Note: The Cat 1900 has no “show start” command. It automatically saves the running configuration to NVRAM. * Slide 1 of 1 Purpose: This slide shows the format and output of the show running-config and show startup-config commands, which display the active and backup configuration files, respectively. Emphasize: We put these two commands on the same page because it is easy to confuse the two. The show running-config command displays the configuration information in memory, while the show startup-config command displays the backup file. Often in class someone will enter commands and then say that the router did not accept them. This scenario might indicate that the person entered the commands to modify the configuration information in memory, and then entered a show startup-config (show config) to look at the backup file that has not yet been updated to reflect the changes. You must use another command to update the backup file. Default parameters do not display in the running configuration. In Cisco IOS Release 10.2 and earlier, the command write terminal shows the running configuration, and the command show config shows the startup configuration. * Slide 1 of 1 Purpose: Emphasize: Here is a list of some of the configuration modes available. For a complete list of the router configuration modes, refer to the Cisco Documentation CD-ROM. * Slide 1 of 2 Purpose: This page explains how to identify routers on the network. Emphasize: Layer 1—To make configuring and maintaining a network easier, several features provide recording and descriptive information in the configuration of the router. The first is the host name, which is simply