国产外输泵在金县1-1油田应用-初级职称论文.docxVIP

国产外输泵在金县1-1油田的应用刘畅摘要金县1-1油田原油外输泵根据ODP相关的原油提供数据采用德国鲍诺曼公司生产的HP 212-28/1螺杆泵，该泵设计粘度为415mpa.s，运转粘度要求在364-381.8mpa.s（70℃）。金县1-1油田经过近四年的试生产，其外输油样化验粘度约在160—230mpa.s范围内波动，该原油粘度低于泵的设计粘度要求，在一定程度造成了外输泵排量降低。同时由于Bornemann泵使用过程中存在设备管理费用高等因素影响。为提升设备管理质量及效率，金县1-1油田响应公司质量效益年相关要求，作业公司和油田通过对多种方案的可行性研究，最终决定对外输泵B泵泵头进行国产化更换。该泵需对泵的轴承座进行优化设计便于现场安装拆卸，同时根据现场实际工况增加机械密封冲洗，并计划通过对该泵的使用效果进行相关评估，以此为依据对后期剩余两台国产化的可行性积累数据及经验。关键词：外输泵，螺杆泵，优化，质量效益AbstractJX 1-1 Oilfield efflux pump available upon foreign oil ODP-related data produced by the German Bornemann HP 212-28/1 efflux pump, the pump is designed viscosity 415 operating viscosity requirements at 364-381.8 (70 ℃). King County 1-1 oilfield after nearly four years of pre-production, the outer oil samples for testing viscosity range of about 160-230 fluctuations in the viscosity of crude oil viscosity is lower than efflux pump design requirements, to a certain extent caused by efflux pump displacement is reduced. And because the higher cost of equipment management and other factors exist Bornemann Pumps use. In order to enhance the quality and efficiency of the device manager, King County 1-1 oilfield quality and efficiency of the company in response to the relevant requirements, operating companies and oil through a feasibility study for a variety of programs, the final decision efflux pump B replacement head the localization. The efflux pump needs to be optimized bearing efflux pump designed for easy on-site installation and removal, and according to the actual site conditions increase the mechanical seal flush, and plans to conduct relevant assessments through the use of the efflux pump effect, as a basis for the latter part of the remaining two domestic feasibility accumulation of data and experience.Keywords: efflux pump, javascript:showjdsw(showjd_0,j_0)screw pump, optimization, quality and efficiency目录一、应用背景4二、国产外输泵方案研究51、结构方案研究52、项目研究内容5三、国产外输泵技术创新51、机械密封冲洗系统52、新型设计轴承座结构6四、国产外输泵技术参数71、主要设计要求技术指标72、螺旋套设计调整73、外输泵性能曲线图9五、国产外输泵调试91、调试前准备92、运转调试10