203 - Personal Protective Equipment (PPE) 个体防护.ppt

E. Respiratory Protection. Employees will wear appropriate respiratory protection when adequate ventilation or substitution with non-toxic chemicals, etc., is not possible or feasible. Respirator protection must comply with ANSI Z288.2-1969 and provisions detailed in OAR 437, Division 2/I 1910.134. F. Fall Protection. Fall protection must be provided when employees are exposed to (1) a vertical fall of ten feet or more over a lower level or (2) any height over dangerous equipment. Fall protection will consist of either passive or active fall protection. Fall protection must comply with ANSI A10.14-1991 and provisions detailed in OAR 437, Division 3, Construction and OAR 437-02-125. G. Electrical Protection. Electrical protective equipment such as insulating blankets, mating, covers, line hoses, gloves, gloves and sleeves must be provided to employees who are exposed to electrical hazards. Electrical protective equipment will comply with the requirements in OAR 437, Division 2/I, 1910.137. V. Monitoring. A. Supervisors will monitor worksite tasks for changes in, or the introduction of new hazards. If new hazards are discovered, they will conduct a task analysis for appropriate PPE. A worksite analysis will be conducted at least annually for each task that requires employees to use PPE. B. The safety committee will monitor the effectiveness of this Plan and make recommendations to management to improve the plan. VI. Review. Reviewed by ______________________________ Date ____________________ Approved by ______________________________ Date ____________________ Sample Personal Protective Equipment (PPE) Test (Supervisors should give this test after training the employee on the proper use and care of PPE. The supervisor should review the test and discuss any areas requiring additional training. When the supervisor is confident that the employee has an adequate knowledge and ability to properly use PPE associated with the job,