Disassembly EasyNote SB Series资料.pdfVIP

Packard Bell EasyNote SB Series Disassembly Guide Table of Contents Overview 3 Technician Notes3 Disassembly Instructions3 Reassembly Instructions 3 Required Tools3 Battery4 Hard disk 4 Optical Drive6 Memory Modules8 Wireless LAN card9 Intel Turbo Memory Module (optional)11 CPU11 Keyboard12 LCD Assembly13 LCD Panel14 Webcam 16 Inverterboard16 Wireless Antenna 16 Top Cover17 Mainboard 18 Bluetooth Module19 USB and Audio board19 DC Jack20 Modem Connector21 Speakers and Subwoofer 22 Button and LED Board and Touchpad22 Reassembly Notes 23 Notice 23 EasyNote SB Disassembly Manual 2 Overview This document contains step-by-step disassembly instructions for the EasyNote SB series. The instructions are illustrated where necessary with images of the part of the device that is being removed or disassembled. Packard Bell reserves the right to make changes to the EasyNote SB series without notice. Technician Notes Only technicians authorized by Packard Bell B.V. should attempt to repair this equipment. All troubleshooting and repair procedures are detailed to allow only subassembly/module level repair. Because of the complexity of the individual boards and subassemblies, no one should attempt to make repairs at the component level or to make modifications to any printed wiring board. Improper repairs can create a safety hazard. Any indication of component replacement or printed wiring board modifications may void any warranty or exchange allowances. Disassembly Instructions When disassembling the unit, follow these general rules: n Turn off the power and disconnect all cables. n Label all removed connectors. Note where the connector goes and in what position it was installed. n Do not disassemble the unit into parts that are smaller than those specifi