[2018年最新整理]FSG-S-I01DOEIntroductionchineseRevC.pptVIP

dsfajggjfsdh Step 8:Using the ANOVA Table, investigate the P-Values of the main effects. 步骤8: 通过ANOVA数据表, 研究主要影响的P值 Use Stat DOE Factorial Plots Main Effects Plot UseStat DOE Factorial Plots Cube Plot FN: Centerpt.mtw 2k Example with Center Points (8):中心点2k 示例(8) Step 9:State the mathematical model obtained. A simpler model is always preferable. (Why?) 步骤9: 解释所得到的数学模式, 模式越简单越好(为什么?) For the yield of product 1, we can reduce the model because the interaction is not significant. 对于产品1的结果, 可以简化模式, 因为交互作用可以被消除. For the yield of product 2 (yield2), we haven’t yet obtained a working model (interaction is insignificant. At this point, we simply know the main effects and curvature exist.) We need more data points for Multiple Regression Analysis, possibly using higher order terms in the equation. 对于产品2的结果, 我们还不能遵循一个工作模式(交互作用是有影响的, 在这一点上, 我们可以直接知道主要影响和弯曲度的存在). 我们需要更多的数据进行多变量回归分析, 变量的选择可以从公式中系数高的项目. Note: Curvature significant 注: 弯曲是有影响的. Note: The above equation is for coded variable levels only! Product 1 (Reduced Model): 2k Example with Center Points (9):中心点2k 示例(9) Step 10:Translate the mathematical model into process terms. Formulate conclusions and recommendations. 步骤10: 把得到的数学模式运用到实际过程中, 并阐述实验结论和改进建议. For product 1: To increase yield we should set the current process to run at 160 degrees and 40 seconds per cycle. 对产品1: 要改进结果, 当前的过程温度应设置在160度, 时间设置在40秒. We also recommend follow-up investigation be done to see if yield can be improved further at factor levels not yet tested in this experiment. For product 2: We recommend that the current process be run at 155 degrees and 35 seconds per cycle. 对产品2: 要改进结果, 当前的过程温度应设置在155度, 时间设置在35秒. We suggest more advanced methods be used to characterize (find an equation) the process. 也可以采用一些更先进的方法来 Step 11:Replicate optimum conditions. Plan the next experiment or institutionalize the change. 步骤11: 优化的设置的实际运用. 计划做下一步的实验或规范化变更. 2k Example with Center Points (10-11):中心点2k 示例(10-11) Clas