不同隙料厚度对CerecBlocs全瓷冠适合性影响的-第三军医大学学报.DOC

不同隙料厚度对全瓷冠适合性影响的实验研究申丹凤王 璐（重庆医科大学附属口腔医院修复科，重庆 重庆市口腔疾病与生物医学研究中心 重庆 ） 目的 研究InLab MC XL系统不同隙料厚度Cerec Blocs全瓷冠边缘和内部适合性的影响。制备一右上颌第一磨牙全冠预备体模型翻制硅橡胶阴模，分别灌制全瓷石膏、超硬石膏预备体模型各30个30个全瓷石膏预备体用于光学印模采集，获得30个代型随机分为0μm（A组），10μm（B组），20μm（C组），30μm（D组），40μm（E组）50μm（F组）6组每组各5个。30个超硬石膏预备体用于全瓷冠粘结经包埋、剖开后，体式显微镜扫描试件剖面。结果 C、D组边缘适合性均介于30μm～120μm，内部适合性均介于30μm～300μm。C组与D边缘适合性比较有统计学差异（P0.05）C、D组内部适合性不均匀，面适合性较。结论 隙料厚度为20μm0μm时，全瓷冠的边缘和内部适合性30μm组的边缘适合性优于20μm组20μm、30μm组。 关键词隙料厚度全瓷冠适合性Experimental study the effect of different luting spaces on the fits of all-ceramic crowns Shen Danfeng,et al （The?Affiliated?Hospital?of?Stomatology,?Chongqing?Medical?University ,Chongqing? Research?Center?for?Oral?Diseases?and?Biomedical?Science, Chongqing 400015，China） Objective To study the effect of different luting spaces on marginal and internal fits of Cerec Blocs all-ceramic crowns in InLab MC XL system. Methods A right maxillary first molar in the standard model was prepared and subsequently replicated into silicone rubber negative mold. Respectively, irrigated thirty preparations of all-ceramic plaster and die stone. Thirty all-ceramic plasters were used for optical impression, then obtained thirty three-dimensional digital images which were randomly divided into 6 groups, and luting spaces were set to 0μm (A group), 10μm (B group), 20μm (C group), 30μm (D group), 40μm (E group) and 50μm (F group) by computer software. The experiment obtained thirty all-ceramic crowns and each group had five ones. In addition, thirty die stones were prepared for bonding of the all-ceramic crowns. After being bonded, embedded and slitted, these specimens were scanned by the stereo microscope. Results The marginal fits were among 30μm~120μm and the internal fits were among 30μm~300μm in C, D groups. There were statistically significant differences（P0.05）between C group and D group in the marginal fits The fits of occlusal surface were both higher than other parts of the internal fits in C, D groups. Conclusions All-ceramic crown