用静态路由及RIP实现不同网段之间互访.docVIP

用静态路由及RIP实现不同网段之间互访 路由器jtwh f0/0: 192.168.23.1 lo0:10.10.10.0 f0/1:为外网地址218.108.32.208/29 路由器jtwh2 f0/0:192.168.23.2 lo0:10.10.20.0 一 静态 jtwhen jtwh#conf t jtwh(config)#int lo0 jtwh(config-if)#ip add 10.10.10.1 255.255.255.0 jtwh(config-if)#int f0/0 jtwh(config-if)#no sh jtwh(config-if)#ip add 192.168.23.1 255.255.255.0 jtwh(config-if)#end jtwh#conf t jtwh(config)#ip route 10.10.20.0 255.255.255.0 192.168.23.2 //静态指向 jtwh(config)#end jtwh#sh ip route //查看路由表 ...... Gateway of last resort is 218.108.32.209 to network 0.0.0.0 10.0.0.0/24 is subnetted, 2 subnets C 10.10.10.0 is directly connected, Loopback0 S 10.10.20.0 [1/0] via 192.168.23.2 C 192.168.23.0/24 is directly connected, FastEthernet0/0 C 218.108.32.0/24 is directly connected, FastEthernet0/1 S* 0.0.0.0/0 [1/0] via 218.108.32.209 测试ping jtwh#ping 10.10.20.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.10.20.1, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 47/59/78 ms jtwh2en jtwh2#conf t jtwh2(config)#int lo0 jtwh2(config-if)#ip add 10.10.10.1 255.255.255.0 jtwh2(config-if)#int f0/0 jtwh2(config-if)#no sh jtwh2(config-if)#ip add 192.168.23.1 255.255.255.0 jtwh2(config-if)#end jtwh2#conf t jtwh2(config)#ip route 10.10.10.0 255.255.255.0 192.168.23.1 测试ping jtwh2#ping 10.10.10.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.10.10.1, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 47/59/64 ms 二 RIP jtwh#conf t jtwh(config)#no ip route 10.10.20.0 255.255.255.0 192.168.23.2 删除之前的静态 jtwh(config)#router rip 启用RIPV2 jtwh(config-router)#ver 2 jtwh(config-router)#no au 关闭自动汇总 jtwh(config-router)#net 10.10.10.0 发布网段 jtwh#sh ip route ...... Gateway of last resort is 218.108.32.209 to network 0.0.0.0 10.0.0.0/24 is subne