基于单片机的温度监测与控制系统程序论文.docVIP

//------------------------------------------------------------------------ // 名称：用1602LCD与DS18B20设计的温敏报警器（含读ROM CODE,温度上下限显示） //------------------------------------------------------------------------ // 说明：本例将报警温度为高：70℃，低：-20℃ 当DS18B20感知温度达此临界 // 值时对应的LED闪烁，且发出警报声。 // 本例还可以显示DS18B20的ROM CODE及报警温度上下限。 //------------------------------------------------------------------------ #include reg51.h #include intrins.h #define uchar unsigned char #define uint unsigned int #define delayNOP() {_nop_();_nop_();_nop_();nop_()} sbit HI_LED = P2^3; // 高温，低温报警闪烁LED sbit LO_LED = P2^6; sbit DQ = P3^3; //DS18B20 数据线 sbit BEEP = P3^7; //报警器 sbit RS=P2^0; sbit RW=P2^1; sbit E=P2^2; sbit K1=P1^7; //正常显示温度，越界时报警 sbit K2=P1^4; //显示报警温度 sbit K3=P1^1; //查看ROM CODE uchar code RomCodeStr[]={-- ROM CODE --}; uchar RomCode[8]={0x00,0x00,0x00,0x00,0x00,0x00,0x00,0x00};//64位ROM CODE uchar code Temp_Disp_Title[] ={Current Temp:}; uchar Current_Temp_Display_Buffer [ ] ={TEMP: }; uchar code Temperature_Char[8] ={0x0C,0x12,0x12,0x0C,0x00,0x00,0x00,0x00}; //温度字符 uchar code Alarm_Temp[] = {ALARM Temp HI LO}; uchar Alarm_HI_LO_STR[] ={HI: LO： }; uchar temp_date[2]= {0x00,0x00}; uchar temp_alarm[2]= {0x00,0x00}; uchar display[5] = {0x00,0x00,0x00,0x00}; uchar display1[3] = {0x00,0x00,0x00}; uchar code df_Table[] = {0,1,1,2,3,3,4,4,5,6,6,7,8,8,9,9}; char Alarm_Temp_HL[2] ={ 70, -20 }; uchar CurrentT = 0; //读取当前的温度整数部分 uchar Temp_Value []= {0x00,0x00}; //从DS18B20读取的温度值 uchar Display_Digit[]={0,0,0,0}; bit HI_Alarm = 0 , LO_Alarm = 0; bit DS18B20_IS_OK = 1; uint Time0_Count = 0; //------------------------------------------------------- //延时 //------------------------------------------------------- void DelayXus(int x) { uchar i; while(x--) for(i=0; i200;i++); } bit LCD_Busy_check( ) { bit result; RS=0;RW=1;E=1;DelayXus(4); result=(bit)(P0 0x80);E=0;