DECT60規格.docVIP

5 DECT UPCS 1 920 MHz to 1 930 MHz FCC requirements This clause provides a reference and/or explicitly specifies requirements to DECT terminals/systems implementations to satisfy the specific UPCS 1 920 MHz to 1 930 MHz FCC requirements [25]. 5.1 Carrier frequencies DECT equipment for the UPCS band 1920 MHz to 1930 MHz shall operate on any or all of the 5 carriers 1921,536 MHz, 1923,264 MHz, 1924,992 MHz, 1926,720 MHz and 1928,448 MHz. See EN 300 175-2 [2], clause F.2. DECTはUPCS band 1920MHz - 1930MHz間の５キャリア1921,536MHz 1923,264 MHz 1924,992 MHz 1926,720 MHz 1928,448 MHz EN 300 175-2 [2], clause F.2参照． 5.2 Antenna connector FCC references: Part 15 [25], section 15.317. 　　 It is required that if the external antenna is detachable, the connector shall not be of standard type. This requirement does not apply if the transmitter equipment has to be professionally installed. FCC 引用: Part 15 [25], section 15.317もし外部アンテナが取り外せるならばコネクターは標準タイプでないことが要求されこの要求はもしがならば適用されない 5.3 RF frequency stability ETSI reference: EN 301 406 [9], clause 4.5.1 referring to EN 300 175-2 [2], clause 4.1.2. FCC references: Part 15 [25], section 15.323(f). ANSI references: C63.17 [26], clause 6.2.1. EN 301 406 [9], requires ±25 ppm and the FCC requires ±10 ppm at extreme temperatures as defined by the　manufacturer, see C63.17 [26], clause 6.2.1. The equipment shall fulfill the FCC requirements. ETSI 引用: EN 301 406 [9], clause 4.5.1 referring to EN 300 175-2 [2], clause 4.1.2. FCC 引用: Part 15 [25], section 15.323(f). ANSI 引用: C63.17 [26], clause 6.2.1. ANSI C63.17[26],clause 6.2.1.製造によって定義される極端な温度の場合 EN 301 406 [9] ±25 ppm FCC要求 　±10 ppm はFCC要求を満たす． 5.4 Peak transmit power ETSI references: EN 301 406 [9], clause 4.5.4. FCC references: Part 15 [25], sections 15.303(c), 15.319(c) and 15.319(e). ANSI references: C63.17 [26], clauses 4.3.1, 6.1.2 and 6.1.3. PNTP shall be 100 × B? mW, where the B is the bandwidth in MHz. This bandwidth is defined in Part 15.303(c). B for DECT could be varied from 1,5 MHz