GME7834(中文).docVIP

General Specification All Vehicle  GME7834  弧焊和激光焊接 GME7834 1.1.2 Joint Shapes. The brazing can be either as butt, fillet or flanged joints. 1.1.3 Brazing Processes. The following brazing methods can be used: 1.1.3.1 Electric Brazing. 1.1.3.1.1 Inert Arc Brazing. 1.1.3.1.1.1 Metal Gas shielded Arc Brazing. ? Metal inert gas brazing (MIG) ? Metal active gas brazing (MAG) ? Metal active gas brazing with cored wire electrodes ? Metal inert gas brazing with cored wire electrodes 1.1.3.1.2 Tungsten-protective Gas Brazing. ? Tungsten-inert gas brazing (TIG) ? (Tungsten)-plasma brazing 1.1.3.2 Laser Brazing. 1.1.3.2.1 CO2 (Gas-) Laser. 1.1.3.2.2 Solid State Laser. GM EUROPE ENGINEERING STANDARDS 1.1.2 接头情况：钎焊可以是对接、角或者凸缘焊接。 1.1.3 钎焊流程：可以利用以下的钎焊方法 1.1.3.1电热钎焊 1.1.3.1.1惰性电弧钎焊 1.1.3.1.1.1 金属气体屏蔽电弧钎焊 ? 金属惰性气体钎焊 (MIG) ? 金属活性气体钎焊 (MAG) ? 金属活性气体药芯焊丝钎焊 ? 金属惰性气体药芯焊丝钎焊 1.1.3.1.2钨气体保护焊 ? ? 钨等离子钎焊 1.1.3.2 激光钎焊 1.1.3.2.1 二氧化碳气体激光 1.1.3.2.2 固体激光  1.2 Mission / Theme. This specification describes  1.2 目的 the general requirements and the appearance of elec- tric brazing joints on copper basis and contains gen- eral references to the design of a brazing joint, if it is not specified in detail on the drawing. Pressure welded joints are detailed in QT 001130 and fusion welded joints are detailed in QT 001131. 1.3 Classification. Not applicable. Note: Nothing in the specification, however, super- sedes applicable laws and regulations unless a spe- cific exemption has been obtained. Note: In the event of a conflict between the German and the English language, the German language shall take precedence. 此规范描述了总体要求和电动钎焊铜接头基础的外观和包含一般提到的，如果它QT 001130，功能焊接接头则参考QT 001131 1.3 种类 不适用 注意：规范中没有任何说明。但是如果得到特定的豁免可以用同等的法律和规则替代。 注意：如果在英语和德语之间有冲突，则德语优先。  ? Copyright 2002 General Motors Corporation All Rights Reserved Not for Resale  GM EUROPE ENGINEERING STANDARDS 2 References  2 参考 GME7834  Note: Only the latest approved standards are appli- cable unless otherwise specified. 2.1