DC03钢静态再结晶模型的研究-钢铁钒钛.PDFVIP

第34卷第2期 钢摇 铁摇 钒摇 钛 Vol.34,No.2 2013年4 月 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 IRON STEEL VANADIUM TITANIUM 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 April2013 DC03 钢静态再结晶模型的研究 李立新,雷摇 浩,方燕子,袁摇 翔,苏雨萌,皮大光 (武汉科技大学材料与冶金学院,湖北 武汉430081) 摘摇 要:运用正交设计的试验方法,在高温箱式电阻炉内模拟DC03钢高温短时连续退火和低温长时罩式退火工艺 条件,采用后插法计算出DC03钢冷轧后各种退火条件下的静态再结晶软化率,研究其与变形程度、退火温度和退 火时间的关系。 选用Avrami方程建立模型并与热加工两道次间的静态再结晶动力学模型作对比。 研究结果表明: 退火温度对热加工两道次间的静态再结晶率影响程度比对冷轧后的退火静态再结晶率影响程度大,而保温时间对 冷轧后的退火静态再结晶率影响程度比对热加工两道次间的静态再结晶率影响程度大。 关键词:DC03钢;高温短时退火;低温长时退火;静态再结晶 中图分类号:TG142郾1摇 摇 文献标志码:A摇 摇 文章编号:1004-7638(2013)02-0098-05 DOI:10.7513/ j.issn.1004-7638.2013.02.019 Study on the Model for Static Recrystallization of DC03 Steel Li Lixin,Lei Hao,Fang Yanzi,Yuan Xiang,Su Yumeng,Pi Daguang (College of Materials Science and Metallurgical Engineering,Wuhan University of Science and Technology, Wuhan 430081,Hubei,China) Abstract:Throughthemethodof orthogonal design,experimentswerecarriedoutto simulatetheprocess conditions of high鄄temperature short鄄time continuous annealing and low鄄temperature long鄄time batch an鄄 nealing of DC03 steel inthehigh鄄temperature chamber鄄type electricresistancefurnace. Staticrecrystalli鄄 zation softening rate of DC03 steel under various annealing conditions after cold rolling was measured by using back鄄extrapolation method and its relationship with deformation degree,annealing temperature and annealing time was studied. The model wasbuilt based on Avrami equation and comparedwith static re鄄 crystallization kinetics model in double鄄passhot working. The result indicatesthat annealing temperature has more influence on static recrystallization rate between two passes of hot deformation than that after cold rolling while the influence of holding time on