信力隆开关电源SM60 Command Basic 22March04通讯协议.docVIP

SM40/SM60 Basic Commands Note: the following command examples apply to SM40/60 version 3.00 software (MIB21). Earlier versions of SM40/60 do not support system alarm numbers after 23. (1) DL_CONNECT This is a data link layer command that is sent from the master to a slave. A slave must receive this command before it can accept messages containing data. Note: 7D are used as an escape code in the following examples, Refer section 4.2.6 of document D20877) Example: Sent Message 0x 7E 7D 20 7D 21 40 7D 21 7D 21 8D 36 Received Message 0x 7E 7D 20 7D 21 86 7D 21 FF 7D 37 B0 (2) Read Real Time values Object Name: Bus Voltage Description: The voltage of the bus, as sensed by the SM60. Command Id: 16510 (Position 1 of 9) Syntax: Floating-Point Access: read-only Object Name: Load Current Description: The current to the load, as measured by the load current shunt(s), if fitted. Command Id: 16510 (Position 2 of 9) Syntax: Floating-Point Access: read-only Object Name: Battery Current Description: The current to the battery, as measured by the battery current shunt(s), if fitted. A positive current is charging the batteries, a negative current is discharging. Command Id: 16510 (Position 3 of 9) Syntax: Floating-Point Access: read-only Object Name: Battery Temperature Description: The temperature of the battery as measured by the battery temperature sensor. Command Id: 16510 (Position 4 of 9) Syntax: Floating-Point Access: read-only Object Name: Rectifier Current Description: The total current from all rectifiers in the system. Command Id: 16510 (Position 5 of 9) Syntax: Floating-Point Access: read-only Object Name: Percentage Max Power Description: The output power of the system as a percentage of the total nominal power the system is capable of supplying. Command Id: 16510 (Position 6 of 9) Syntax: Floating-Point Access: read-only Object Name: Total Load Power Description: The power being used by the load. Command Id: 16510 (