美国Dynex丹耐克斯高压活塞泵.docVIP

美国Dynex丹耐克斯高压活塞泵 H Series High Pressure Piston Pumps H系列高压柱塞泵 High pressure pumps operate with extended life at pressures to 10 000 psi (700 bar). 10 000 psi（700 bar）的压力，高压泵运行，延长使用寿命。 These fixed displacement piston pumps include models in these Series: 这些固定排量活塞泵在这些系列包括型号： PF1000H-10 PF1000H-10 PF3000H-10 PF3000H-10 PF4000H-30 PF4000H-30 The pumps provide a range of output flows from 1.5 to 17.2 gpm (5,7 to 65,1 L/min) at 1800 rpm . 该系列泵的输出流量提供了一个范围从1.5到17.2加仑（5,7至65,1 L /分钟），在转速为1800 rpm。 High Efficiency Design 高效率的设计 The checkball pump design uses piston check valves to direct flow from the pump inlet to the outlet. 的checkball泵的设计使用活塞止回阀直接从泵的入口到出口的流动。 The positive-seating check valves provide high volumetric efficiency, especially at higher pressures. 阳性座位止回阀提供高的容积效率，特别是在较高的压力下。 Contamination Tolerant 污染容错 The outlet check valves provide a relatively large flushing path for any system contamination. 的出口单向阀提供了一个相对大的冲洗路径的任何系统的污染。 This makes the pumps ideal for systems where the fluid cannot be totally cleaned by filtration, or where it is just not economical. 这使得泵流体不能被完全清除，通过过滤，或它仅仅是不经济的系统的理想选择。 Multiple Output Models 多输出模型 Split-Flow ? pumps provide multiple outputs for synchronized actuator movement or multiple function circuits. 分流 ? 泵提供多路输出同步执行器的运动或多个功能电路。 These multiple outlet pumps can efficiently supply flow in a circuit with changing flow and pressure requirements. 这些多出口泵可以有效地改变流量和压力的要求，提供在一个电路中流动。 This makes them ideal for Hi-Lo circuits on clamping, pressing, high-torque tools and other similar applications. 这使得它们非常适合用于Hi-Lo的电路夹紧，冲压，高扭矩工具和其他类似的应用程序。 泵的选型注意事项 Output flows listed are based on typical performance at rated pressure with pressurized inlet where required. Consult the Dynex sales department for minimum inlet pressure and for a review of applications requiring operation above the rated speed of 1800 rpm. 输出流量是根据典型的表现在有需要时，在额定压力入口压力。最小进口压力和需要操作的额定转速1800转以上的应用程序进行审查，咨询Dynex的销售部门。 Ordering these pumps requires a complete model code specifying driv