A466277(英).pptVIP

* * A466167英 Consider a regenerative cycle using steam as the workingfluid. Steam leaves the boiler and enters the turbine at 4 MPaand 400 ℃. After expansion to 400kPa, some of the steam isextracted from the turbine for purpose of heating the feedwater in an open feedwater heater.The pressure in the feedwater heater is 400kPa and the water leaving it is saturated liquid at 400kPa. The steam not extracted expands to 10kPa.Determine the cycle efficiency. Analysis As in example A466167, the process is steady state and kinetic and potential energy changes are negligible. And from the example we have the following properties: Also, at p6=400kPa, from the second law, ?First consider the low-pressure pump Control volume: Low-pressure pump Inlet state: p1known, saturated liquid; state fixed Exit state: p2known. Solution The first law is Therefore ?Next consider the feedwater heater Control volume: Feedwater heater. Inlet states: States2 and 6 both known(as given). Exit state: p3known, saturated liquid; state fixed Control volume: turbine Inlet state: p5,T5known; state fixed Exit state: p6known; p7known. ? For the turbine we have The first and the second laws are The first law gives us Substituting, we obtain We can calculate the turbine work ?Finally for the boiler Control volume: Boiler Inlet state: p4,h4known(as given); state fixed. Exit state:State 5 fixed(as given) . The first law is Substituting gives Therefore, Note the increase in efficiency over the efficiency of the Rankine cycle of example A4