防尘扣盖注塑模（cad）.doc

摘 要  ABSTRACT At present, injection molding is the plastics mould that has being used most extensively , it can mold the complex and high accurate plastic product. The subject is about the mold design of the dustproof buckle cover and the process analysis. Considering the annual output, the degree of complex and the requirement of precision of the plastic product, two cavities in a mould is a more manner. A level horizontal parting surface and two side core pulling mechanismths are choosed as the parting line to make the mold of the buckle cover demolded successfully. The spruce uses the cold-slug well with back taper to pull the spruce solidified materials when ejecting. The runner is designed to be balanced and symmetrical distribution, ensure that melting plastic could reach each cavity抯 gate almost. Suspension and Positioning mechanism use matched guide pillar and guide sleeve to make movable mould, fixed mould to work accurately. The knockouts uses once ejecting mechanism that lifter pushes out. By the relation of the position of each part, cooling channels are designed to linear channels to cool effectively, quickly. With Pro/Engineer to implement three-dimensional design of the dustproof buckle cover and the design of molding parts ,and shaping quality of part was analyzed by Moldflow, then accomplish the assemblage of the mold with the assistance of essential theory calculate mixed with computer-aided design. It would not only shorten the cycle of product research and mold design, and improve the preciseness and the product shaping quality, but also lower the cost of the research. Having made the rational craft scheme in the design process, so it has met the requirement of producing in enormous quantities. Key words: injection mold dustproof buckle cover Pro/E Moldflow 目 录 1 绪论 1 1.1 课题内容 1 1.2 课题背景 1 1.3 课题的来源及要求 2 1.4 模具国内外发展概况 2 2 总体设计方案 4 2.1 塑件的结构图 4 2.2 塑件的分析 6 3 MOLDFLOW分析 7 3.1 最佳浇口分析 7 3.2 填充分析 8 3.3 流动与翘曲分析 9 3.4 模流分析总结