ENERGY STAR Lamps V1 0 Final Test Methods and Recommended Practices浅析.pdfVIP

ENERGY STAR® Program Requirements Product Specification for Lamps Version 1.0 : Ambient Temperature Life Testing Test Method August-2013 1 OVERVIEW The following test method shall be used for determining product compliance with the Lumen Maintenance and Rated Life requirements in the ENERGY STAR Eligibility Criteria for Lamps. 2 APPLICABILITY ENERGY STAR test requirements are dependent upon the product technology, category and/or power consumption of the product under evaluation. The following guidelines shall be used to determine the applicability of each section of this document:  The Ambient Temperature Life Test (ATLT) applies to decorative solid state lighting (SSL) lamps of all wattages, omnidirectional SSL 10 watts (W), all SSL lamps labeled “not for use in recessed fixtures” and all omnidirectional SSL lamps labeled “not for use in enclosed fixtures”.  The test procedures in Section 7 shall be performed on products that are required to undergo the Ambient Temperature Life Test in the Supplemental Testing Guidance for Lumen Maintenance and Rated Life Requirements. 3 DEFINITIONS Unless otherwise specified, all terms used in this document are consistent with the definitions in the ENERGY STAR Eligibility Criteria for Lamps. ENERGY STAR Program Requirements for Lamps Version 1.0 - Ambient Temperature Life Test Method - Final (August-2013) Page 1 of 4 4 METHODS OF MEASUREMENT AND REFERENCE DOCUMENTS 4.1 IES Test Methods and Reference Documents A) IES LM-65-10. 2010. IES Approved Method for Life Testing of Compact Fluorescent Lamps, Illuminating Engineering Society, New York. B) IES LM-79-08. 2008. IES Approved Method for Electrical and Photometric Measureme