LCD1602测试程序.docVIP

#includereg52.h #define uchar unsigned char #define uint unsigned int //*************************** sbit RS=P2^4; sbit RW=P2^5; sbit EN=P2^6; //****lcd1602驱动程序******** void delay_ms(uint z); bit check_busy(); void write_com(char com); void write_dat(uchar date); void lcd_dis_char(char x,char y,uchar date); void lcd_dis_str(uchar x,uchar y,uchar *str); void lcd_int(); void lcd_clean(); //************************** void delay_ms(uint z) //延时 { uint x,y; for(x=z;x0;x--) for(y=124;y0;y--); } bit check_busy()//查忙 { bit result; RS=0; RW=1; EN=1; delay_ms(2); result=(bit)(P00x80); EN=0;//一定要拉低，否则后面不能使能 return result; } void write_com(char com) //写命令 { while(check_busy());//等于1就等待 EN=0; RS=0; RW=0; delay_ms(1); EN=1; P0=com; delay_ms(1); EN=0; } void write_dat(uchar date)//写数据 { while(check_busy()); EN=0; RS=1; RW=0; delay_ms(1); EN=1; P0=date; delay_ms(1); EN=0; } void lcd_dis_char(uchar x,uchar y,uchar dat) //液晶定位和写单个的字符 { uchar address; if(y==1) address=0x80+x; //0=x16; else address=0x80+0x40+x; write_com(address); write_dat(dat); } void lcd_dis_str(uchar x,uchar y,uchar *str)//定位并写字符串 { uchar address; if(y==1) address=0x80+x; //0=x16; else address=0x80+0x40+x; write_com(address); while(*str!=\0) { write_dat(*str); str++; } } void lcd_int() //1602的初始化 { write_com(0x38); delay_ms(1); write_com(0x0c); delay_ms(1); write_com(0x06); delay_ms(1); write_com(0x01); delay_ms(1); } void lcd_clean()//清屏 { write_com(0x01); delay_ms(1); } void main() { lcd_int(); lcd_dis_str(2,1,welcome!!!); lcd_dis_str(2,2,LED TEST); delay_ms(1500); //lcd_clean(); while(1); }