ads教程英文版lab9.pdfVIP


 ADS Fundamentals – 2009 
 
 LAB 9: Final System and Circuit Simulations 
 Overview
–
This
last
lab
exercise
brings
together
all
the
circuits
built
during
the
course:
 the
amplifier
and
filters.
They
replace
the
behavioral
system
models
used
in
the
earlier
 exercise.
 
 

 
 OBJECTIVES • Create
a
sub‐circuit
for
the
1900
MHz
amplifier
for
use
in
the
system.

 • Use
the
Smart
Simulation
Wizard.
 • Set
up
and
run
a
CE
simulation
using
a
CDMA
source.
 • Simulate
ACPR
and
power
specs
using
an
example
data
display.
 • Program
Marker
sliders
to
customize
data
displays.
 • OPTIONAL
‐
Co‐simulations
with
minimal
instructions.
 
 
 
 
 
©
Copyright
Agilent
Technologies
 2009
 Lab 9: Final System and Circuit Simulation 
 TABLE OF CONTENTS 
 1. Create the final AMP_1900 sub-circuit for the library. 3 2. Simulate AMP_1900 with the Smart Simulation Wizard. 4 3. Create the final HB swept LO schematic and equations. 6 4. Final HB simulation: 2 tones with swept LO power and noise. 8 5. Plot the data: NF, Conv Gain, dbm_out, and IF_gain. 10 6. Final Envelope simulation: CDMA source. 11 7. Use an Example DDS to plot ACPR and Power for your circuit 13 8. Plot the spectrum using a programmed marker slider. 14 9. CDMA Envelope Simulation with Frequency Sweep 17 10. OPTIONAL - Co-simulation of the behavioral RF system. 22 
 
 
 9‐2