ADI仪表放大器设计指南.docVIP

ADI仪表放大器设计指南 第3章1/6 本章目录： 原标题 正文页码 第三章 有效地使用仪表放大器 Chapter I I I—Applying In-Amps Effectively 27 双电源工作 Dual Supply Operation 27 单电源工作 Single Supply Operation 27 电源旁路、退耦与稳定性讨论 Power Supply Bypassing, Decoupling, And Stability Issues 27 输入地回路的重要性 The Importance Of An Input Ground Return 27 电缆终端 Cable Termination 28 输入端的静电放电和直流过载保护 Input Protection Basics For ADI In-Amps 29 ◎◎ESD静电和直流过载的输入保护 Input Protection From ESD And DC Overload 29 ◎◎增加外接保护二极管 Adding External Protection Diodes 30 ◎静电和短时过载保护 Esd And Transient Overload Protection 31 影响直流精度的详细讨论 Design Issues Affecting DC Accuracy 31 ◎最低可能的偏置电压误差 Designing For The Lowest Possible Offset Voltage Drift 31 ◎最低可能的增益误差 Designing For The Lowest Possible Gain Drift 31 ◎实际问题解答 Practical Solutions 33 TRI和TRO误差 Rti And Rto Errors 33 ◎减少射频干扰引入的误差 Reducing Errors Due To Radio Frequency Interference 34 ◎其它设计问题的讨论 Miscellaneous Design Issues 36 Applying In-Amps Effectively有效地使用仪表放大器DUAL SUPPLY OPERATION???????双电源工作 原文内容 译文 注释 疑虑 [301]The conventional way to power an in-amp has been from a “split” or dual polarity power supply. This has the obvious advantage of allowing both a positive and a negative input and output swing. 通常,给仪表放大器供电的是将一个电源分成正,负两部分,或双极性的电源.这样做明显的优点是允许放大器输入输出正,负信号。 SINGLE SUPPLY OPERATION???????单电源工作 [302]Single supply operation has become an increasingly desirable characteristic of a modern in-amp. Many present-day data acquisition systems are powered from a single low voltage supply. For these systems, there are two vitally important characteristics. The first is that the in-amp’s input common-mode range should extend between the positive supply and the negative supply (or ground). Second, the amplifier’s output should be “rail-to-rail” as well, providing an output swing to within 100mV or less of either supply rail or ground. In contrast, a standard dual supply in-amp can only swing to within a volt or two of either supply or gro