Version50修改版.docVIP

V50 TroubleShooting 1.R6 BB2 IP address is not correct. R6的BB2地址配错了 2.The f0/10 port on which between Sw3 and BB3 has been configured SPAN, this is port is in the monitoring down status. Remove the configuration. SW3连接BB3的F0/10 配置了SPAN删掉这个配置 3.SW1 has the loopback 200 IP address.删掉这个配置 4.R2的21网段配置在串口S0/0上 Section 1:Bridging and Switching 1.1 Frame Relay R3 P-T-M sub interface R4/R5 P-T-P sub interface R1/R6 phsical interface Check command: ping, show frame-relay pvc or frame-relay map 1.2 Port-channel between SW1 and SW2 ? Sw1 and Sw2 Layer 3 Ether Channel use port-channe 21 only ?Assign YY.YY.100.1/24 to SW1 port-channel 21 ?Assign YY.YY.100.2/24 to SW2 port-channel 21 ? Ensure interface F0/23 and F0/24 are channel member for both switch ? Do NOT reply on PAgP of LACP to facilitate the connection (mode on) ? Verify Layer 2 and Layer 3 connectivity via channel link interface FastEthernet0/23 -24 no switchport channel-group 21 mode on interface Port-channel21 ip address Y.Y.100.1/2 Check command: show etherchannel,show ip int port-channel… 1.3 Port-channel between Sw1, Sw3 and Sw2, Sw4 ? Sw1, Sw3, Sw2 and Sw4 Layer 2 Etherchannel use port 10 only. ? F0/19 and F0/20?are members of switches. ? On Sw2 and Sw4 assign all interface in the Etherchannel as static-access port in VLAN_200 Uncondition enable PAgP to facilitate the connection. ? Verify Layer 2 connectivity via channel link. Sw1,3: interface FastEthernet0/19-20 switchport trunk encapsulation isl 考试时考虑用desirable switchport mode trunk channel-group 10 mode desirable Sw2,4: interface FastEthernet0/19-20 switchport mode access switchport access vlan 200 channel-group 10 mode desirable ?1.4 VTP VLAN After finished all of configuration,SW1,SW2 and SW3 should be able to access all the network. SW1 - SW4 VTP domain name VTPYY, VTP mode transparent. SW1: VLAN ID???????? ?Name??????????????????????????????????????????Status????????????????????? ?? Ports 40 VLAN_BB1 acti