基于TR1001OOKASK868.35MHZ收发器电路设计.doc

课程设计 题 目 基于TR1001 OOK/ASK 868.35MHZ收发器电路设计 学院名称 指导老师 班 级 学 号 学生姓名 　 2011年12月 【摘要】 本设计目的是设计一个以芯片TR1001为核心，频率为868.35MHZ，采用OOK及ASK两种调制方式的收发器。设计方案的接收电路中，射频接收信号经SAW滤波器到达射频放大器，射频放大器的输出到达SAW延迟线，同时，检波器输出驱动回转滤波器提供一个等纹波低通滤波器响应，峰值检波器的输出通过AGC比较器也提供一个AGC复位信号到AGC控制电路。接收器的核心是时序放大接收部分，天线阻抗范围为35～72，外接一个串联匹配线圈和一个并联的ESD保护线圈，从而对RFIO进行匹配。数据限幅器将从BBOUT来的模拟信号转换成数字流。为了避免信号在低通滤波器传递和峰值检波器放电所耗的时间段中AGC发生“颤动”，在 AGCCAP端接入一只电容。接收芯片的放大器时序操作由脉冲发生器和RF放大器偏置电路控制，发射部分由一个调制缓冲放大器后接SAW延迟线（谐振器）构成。 【关键字】 TR1001 OOK ASK 收发器 【Abstract】 The design uses a TR1001 as the core to contrive a transceiver, which worked at frequency of 868.35 MHZ, and had two ways of modulation, named OOK and ASK. RF signals received by the SAW filter at RF amplifiers, the output reached SAW delay line. At the same time, detector output drive rotary filter to provide a ripple, such as low pass filter response. Peak detector output by comparison with AGC and AGC also provide a reset control signal to the AGC circuit. Receiver is the core of timing Larger receive part. Antenna impedance range of 35 to 72, a series matching external coil and a parallel ESD protection coil, thus RFIO match. Data from the limiter for the BBOUT to convert analog signals into digital stream. In order to avoid the signal transmission and low-pass filter peak detector discharge by the consumption of time, the AGC in the vibrate, in the end AGCCAP access a capacitor. To receive the amplifier chip timing operation by the pulse generator and RF amplifier bias control circuit, fired in part by a modulation buffer amplifier followed by SAW delay line (resonator) constituted. 【Key words】 transceiver 目录 1．TR1001芯片简介-------------------------------------------------------------------------------------4 2．TR1001芯片封装与引脚功能--------------------------------------------------