基于NX的某水轮机主轴密封的规范化设计毕业论文推荐.docVIP

本科毕业设计（论文） 基于NX的某水轮机主轴密封的规范化设计 摘要 水轮机是水轮发电成套设备的主机，它与水轮发电机、电站控制设备励磁系统调速器配套使用，组成水力发电站的主体。主轴密封则是水轮机关键部件之一，是水轮机的一项重要保护它装在水导轴承,作用是防止压力水从主轴和顶盖之间渗漏机坑内,淹没水导轴承,破坏水导轴承的工作影响机组的运行。 关键词：水轮机 主轴密封 UG NX 规范化设计 Abstract Water turbine is the host of the power generation equipment. It is supporting the use of the hydrogenerating,power control equipment, excitation system and speed governor,which make up the main component of the hydro power station. Shaft seal is the key component of a water turbine ,also an important safeguard for water turbine. It’s installed in the bottom of the water pilot bearing,the role of which is to prevent the pressure water from leaking into the turbine pit between the main shaft and capping , submerging the water pilot bearing and then damage its work,so that influence the operation of power generation . As a key component of the water turbine, the performance of the shaft seal concerns the maintenance cycle and operation security of the unit directly. In recent years, with the development of CAD / CAE / CAM technology, as well as the popularity and application in the industry of product design,the field of product design and manufacturing is undergoing a profound technological revolution.The traditional two-dimensional design is replaced by the digital design and manufacturing methods,of which definition is based on three-dimensional digital gradually. In this technological revolution, the key is to master the appilication of three-dimensional CAD / CAE / CAM software, and then use in the product design and manufacture for digital. To summarize the experience of actual production, we can easily find that to ensure the quality of products, we must ensure the quality start from designing products. Obviously, the passive measures for quality control of the past is outdated, but should start from the work of product design. So there is a standardization design concept come up: to unify the common parts of the design work in a certain uniform sta