变电所停送电操作规程[精品].docVIP

变电所停送电操作规程 This article is contributed by Hu Pengcheng 263 DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Code for operation of power supply substations First, the power supply of mine is summarized. At present, the power supply line of the middle coal industry is double circuit and 10KV line, which are taken from the 603 cabinets and 620 cabinets of different mother lines of 35KV substation in Cui Jia gou. In addition to the above the line all the power, and 800KVA generator units provided for the main fan, wells on the main winch and ground electricity and underground drainage and local ventilator for temporary use. Two, stop power operation program (1), power failure operation sequence, power failure operation, power failure operation sequence, when the line power failure, according to the following power failure operation order operation. High power procedure: first divided circuit breaker, the handle is screwed to the breaking position locking device, under isolation, isolation, and on the grounding knife, to lock the high-voltage switch power circuit breaker program: - open the isolation and car hanging atresia load power card, no isolation. After the above power failure has been completed, the power failure warning sign must be suspended, and the dispatchers office shall be informed to make a good record. The operation of power cut must strictly carry out the finger oral security confirmation method. Transmission, operation sequence (two) transmission operation sequence, power supply operation, 1 power transmission operation must be identified on the line without staff, another loop and disconnect the generator control cabinet whether power outages and the lock, after confirmation, can according to the rules of procedure of transmission. 2, when the operation of doubt, not allowed to change the operation record and operation ticket, must Report to operator