外文翻译--数控技术的发展精选.docVIP

付：外文翻译 Numerical control technology development Numerical control system develop biref history and trend the first electronic computer in the world borned in 1946, this indicates the mankind has created the tool that can strengthen and replace the mental labour partly . It, and mankind those that create to strengthen tool of manual labor compare among agriculture, industrial society, the qualitative leap has arisen , has established the foundation that the mankind enters the information-intensive society . 6 years later, namely in 1952, the technology of the computer was applied to the lathe , the first numerical control lathe has emerged in U.S.A.. From then on, the traditional lathe had produced the change of the quality. In nearly half a century, numerical control system go through two stage and six development of generation. The stage of numerical control (NC ) (1952-1970 years) The operation of the early computer is low in speed, influence not also big scientific caculation and data processing at that time, but cant meet the needs of real-time control of the lathe . People have to adopt the digital logical circuit to put up and become the special-purpose computer of a lathe as the numerical control system, known as the hardware and connect numerical control (HARD-WIRED NC ) , abbreviate as the numerical control (NC ). With the development of components and parts, does this stage go through y′ú￡?? of the sixth of the twelve Earthly Branches? First generation in 952 --Electron tube ; Second generation in 1959 --Transistor; The third generation in 1965 --Small-scale integrated circuit. The stage of numerical control of the computer (CNC ) (1970 - now) By 1970, the small-scale computer industry in common use has already appeared and produced by batch. Then transplant it over as the key part of system of numerical control, enter computer numerical control stage from now on (whether due in common use two words omit computer). By 1971, in the world for the fi