织金县宝山煤矿矿井设计说明书.docVIP

摘 要 贵州省毕节市织金县以那镇宝山煤矿，织金县宝山煤矿位于织金县以那镇南东，其西部边界紧靠以那镇，矿区边界为一不规则的多边形东界至多吉河，北界至F1断层。井田走向宽km，倾向长约3.km，面积2.8085km2。矿区内交通以公路为主，织金至纳雍、水城的公路从矿区南部经过，以那镇织金3km，至km，至水城123km，贵阳215km，交通较为方便m。岩质不纯，未进行专门采样。 矿井设计开采煤层为井田内的C8煤层，煤的平均厚度分别为1.42m；倾角为9°～13°，平均为11°。矿井按照煤与瓦斯突出、煤层自燃和煤尘具有爆炸性设计。井田的走向长平均为8.2km，倾斜长平均为2.8km，井田面积约为24.9km2；井田内的工业储量约为3663万吨，可采储量为3663万t；矿井的设计年产量为45万t/a，设计服务年限为55a；工作面作业方式采用的是“两班半采煤，半班准备”的工作方式。设计井田内无大的断层和构造，对矿井的正常生产无影响，矿井按高瓦斯矿井设计。井田内采用反斜井单水平上、下山开拓方式，沿井田的倾斜方向，将井田划分成二个阶段，共18个区段进行开采。根据井田内无大的断层和构造特点，准备方式为上下山采区准备，采区内为单层准备。 矿井的采煤方法采用的是单一走向长壁后退式采煤法，回采工艺为综合机械化采煤。井下煤炭主要采用皮带运输机运输，材料和矸石等采用矿用电机车和矿车运输。 通风方式采用中央边界抽出式通风，选用矿用隔爆轴流式通风机，采区进风由副斜井进风，主斜井辅助进风。由于本矿井是高瓦斯矿井，所以采用三条上下山，运输上山采用的是独立通风。运输上山采用的是胶带运输，主斜井采用的是“机轨合一”运输方式；轨道上山布置双轨道，车场均为甩车场 Abstract Pick a song to Zhijin county guizhou province bijie city in the township of baoshan mine, zhijin county, baoshan mine located in zhijin county in south east of the town, close to the town, the west boundary to guizhou zhijin county town 30 km, belong to zhijin county to the town. Mining area boundary is an irregular polygon, the east side to the edge, river, the north side to the F1 fault. Means to the average is about 0.92 km wide, tend to be an average of about 3.1 km long, covers an area of 2.8085 km? The rich coal resources, coal quality is good, suitable climatic conditions. Traffic is given priority to with road in mining area, zhijin to harmony, south shuicheng road (S307) from mining through, to the town to 30 km, zhijin to zhijin coal-fired power plants (town) in eight steps 25 km, and the city 123 km, to guiyang 215 km, from zhijin to the railway line is yellow barrel station began operations, transportation is convenient. Mining in the mine is rich, in addition to coal, clay, limestone, bauxite and bauxitic mudstone, the scattered elements and coal-bed methane, etc. Clay to fired brick, tile, drilling mud and other civilian; Limestone widely distributed, local farmers use burned lime raw materials and buildin