官方说明书intersil X9110 说明书.pdfVIP

X9110 ® Dual Supply/Low Power/1024-Tap/SPI Bus Data Sheet February 13, 2008 FN8158.3 Single Digitally-Controlled (XDCP™) Features Potentiometer • 1024 Resistor Taps – 10-Bit Resolution The X9110 integrates a single digitally controlled • SPI Serial Interface for write, read, and transfer operations potentiometer (XDCP) on a monolithic CMOS integrated of the potentiometer circuit. • Wiper Resistance, 40Ω Typical @ 5V The digital controlled potentiometer is implemented using 1023 resistive elements in a series array. Between each • Four Non-Volatile Data Registers element are tap points connected to the wiper terminal • Non-Volatile Storage of Multiple Wiper Positions through switches. The position of the wiper on the array is • Power-on Recall. Loads Saved Wiper Position on Power-up controlled by the user through the SPI bus interface. The potentiometer has associated with it a volatile Wiper Counter • Standby Current 3µA Max Register (WCR) and four non-volatile Data Registers that • System VCC: 2.7V to 5.5V Operation can be directly written to and read by the user. The contents of the WCR controls the position of the wiper on the resistor • Analog V+/V-: -5V to +5V array though the switches. Power-up recalls the contents of • 100kΩ End to End Resistance