同种聚合物微注塑模内装配的粘附消除方法-机械工程专业论文.docx

同种聚合物微注塑模内装配的粘附消除方法Research on Eliminating Adhesion between Micro Plastic Parts of Same Polymer Molded by in-mold Assembly Inj ectionAbstractIn·mold assembly injection molding of micro plastic parts carl not only reduce secondary operation of assembling various micro plastic parts after demolding and improve efficiency as well as quality of micro assembly，but also innovate structure of the plastic parts and simplify composition of the plastic mechanism．As a result，the operation reliability of the micrO plastic mechanism Can be promoted．On the other hand，if the micro plastic partsmolded by in-mold assembly injection are made of same polymer，requirements forcomplexity and cost of the injection-molding machine Can be reduced，which plays strongrealistic role in practice．How to eliminate adhesion between the micr0 plastic parts molded by in-mold assembling is crucial to quality of in-mold assembly injection molding．In this thesis，the way to avoid adhesion phenomena at the solid-melt interface of same polymer Was analyzed，andexperiments of measuring adhesion strength between the parts injection-molded by samepolymer were carried out．Then the ice-cold system for micro core of the mold was optimized．And the temperature field of the improved refrigeration module Was simulated to shorten timeneeded for eliminating adhesion between tlle micro plastic hole and the micro plastic pinwhich composed the micro plastic hinge and at the time enSUle 900d quality of the microplastic rotating mechanism．The thesis includes the following specific contents．Firstly．in order to find out temperature condition of avoiding inter·surface adhesion between parts of micro plastic hinge molded by same polymer wi也the single-cylinder micro injection molding machine．experiments of the solid-melt interface adhesion between parts injection·molded by same polymer were carried out．And impact of temperature at the curing solid surface on adhesion phenomenon of same polymer Was analyzed tO provide referenceda