官方说明书LINEAR Application Note 119A 说明书.pdfVIP

LINEAR Application Note 119A Manual /file/2625144 From ManualL ManualL collects and classifies the global product instrunction manuals to help users access anytime and anywhere, helping users make better use of products. Home: / Chinese: / This Manual: /file/2625144 Application Note 119A April 2008 Powering Complex FPGA-Based Systems Using Highly Integrated DC/DC µModule Regulator Systems Part 1 of 2 Circuit and Electrical Performance Alan Chern and Afshin Odabaee In a recent discussion with a system designer, the re- contribute to lower system cost, consuming less power quirement for his power supply was to regulate 1.5V to remove heat). Figure 1 shows a test board for such a and deliver up to 40A of current to a load that consisted circuit. The design regulates 1.5V output while delivering of four FPGAs. This is up to 60W of power that must be 40A (up to 48A) of load current. Each “black square” is a delivered in a small area with the lowest height profi le complete DC/DC circuit and is housed in a 15mm × 15mm possible to allow a steady fl ow of air for cooling. The × 2.8mm surface mount package. With a few input and power supply had to be surface mountable and operate output capacitors and resistors, the design using these ® regulator systems is as simple as it’s at high enough effi ciency to minimize heat dissipation. DC/DC μModule