电火花机维护保养细则资料.docVIP

电火花机维护保养细则 Rules for maintenance of EDM machine First page, 4 pages of EDM maintenance rules EDM maintenance rules, EDM maintenance rules EDM maintenance rules, routine maintenance, serial number, time, content requirements Before class 1 (1) check the buttons and switches, knobs and other flexible and reliable, the correct location (2) inspect all safety devices and fastening devices Accurate, flexible and reliable, Wu Song move (3) check all kinds of instrument instructions correctly and sensitively (4) check the oil level, lubricate or lubricate the grease according to the lubrication chart, and make sure the oil flow is smooth (5) perform thermal engine operation, with sufficient movement and lubrication of parts In class 2 (1) strictly adhere to the operating procedures (2) listening, seeing, touching and smelling at any time, observing the running of equipment and dealing with it promptly without trouble After class 3 (1) cleaning chip, wiping the surface, and the sliding taper of spindle Noodles, more than three days without oil to rust Strictly observe (2) the moving parts, keys and switches shall be placed in a reasonable position and strictly observed (3) Cut off the power supply, air supply strictly abide by (4) clean and clean the environment around the machine tools 4 weekend Wipe all parts (including panel, button, etc.), Check the cleaning and filtering device, press the lubrication table and refuel With coolant, check whether the fasteners are loose or not. Cleaning spindle Cone Strictly observe mechanical part level maintenance Serial part content requirements 1 spindle cleaning, spindle chuck clean and burr free 2 the worktable checks the worktable and its T groove to move smoothly, clean and without burrs Three Feed pass Dynamic system (1) check and clean the coordinate direction, the drive mechanism is clean, clean and flexible (2) check each coordinate direction sensor, limit switch, flexible and reliable Four Barometric pressure or Hydraulic sy