如何扫描时使用最高解析度-Canon.PDF

如何掃描時使⽤最⾼解析度 How to scan using highest dpi 雖然Canon 隨附掃描軟件如「IJ Scan Utility」和部份打印機的控制⾯版上可以選擇掃 描解析度，最⾼也只在能選擇600dpi 。 Although Canon’s bundled software likes “IJ Scan Utility” or some of the printer’s control panel can set the scan resolution, the highest dpi is only up to 600 dpi by default. 如需掃描時使⽤更⾼解析度，您需要從電腦進⾏掃描並使⽤掃描器驅動程式 ScanGear 。以下為透過IJ Scan Utility 使⽤ScanGear 的⽅法： If you want to use higher resolution, you need to scan from computer using ScanGear. Please refer to the procedure below to use ScanGear.
 1. ⾸先開啟IJ Scan Utility ，然後按ScanGear 。（如不懂啟動IJ Scan Utility ，可按 此） Start “IJ Scan Utility”, and then click ScanGear. (Click here if you don’t know how to start “IJ Scan Utility”.) 注釋（Remark） • 如需指定在透過啟動ScanGear （掃描器驅動程式）掃描項⽬時如何儲存影像以 及在儲存後如何回應，您可先按「設定」，然後參考以下網⾴進⾏設定： /ij/webmanual/ScanUtility/W/MG3600%20series/1.1/ TC/SU/su-114.html
 If you need to specify how to save images when scanning items by starting ScanGear (scanner driver) and how to respond after saving them, please click “Settings”, and refer to the webpage below for more detail:
 /ij/webmanual/ScanUtility/W/MG3600%20series/1.1/ EN/SU/su-114.html　
 2. 開啟ScanGear後，按右上角「進階設定」。
 When ScanGear is opened, click “Advance mode” on right top corner. 注釋（Remark） • 按「進階設定」後如出現以下對話框，請按「確定」。另如不希望這訊息再次 出現，請剔選「不要再顯⽰此訊息」。
 If the message “Resets the setting to default” appear, click “OK”. You can select “Do not show this message again “if you don’t want this message appear again.
 3. 轉換至「進階模式」後，您可在「輸出解析度」⼿動輸入解析度。（⼿動輸入的數 值範圍為25-19200 ）
 In “Advanced Mode”, you can input the resolution manually. (range between 25 to 19200.) 注釋（Remark） • 請留意 「輸出解析度」或「資料⼤⼩」與⼤，掃描所需時間越耐。
 Please note that if the number of “Output Resolution” or “Data Size” is more larger, more time of scanning is needed.