Robird G31设置说明书英文版.pdf

Ver:Draft 08a for Firmware 0.96a 2012/04/12 Robird G31 Flybarless System Manual Contents 1 Standard receiver connection2 2 Connecting single-line receivers3 3 Servo connection4 4 Power supply4 5 Transmitter setup4 6 Configure G31 by P 4 7 Configure G31 by transmitter5 7.1 Setup menu overview(Menu LEDs steady on)5 7.2 Adjust menu overview(Menu LEDs flashing) 6 8 Setup menu(Menu LEDs steady on)6 0 Receiver Type6 1 Servo Type7 2 Swash Servo Neutral Position7 3 Swashplate Servo Direction8 4 Center servo location Positive pitch direction9 5 Swashplate geometry calibration (Positive/Negative collective pitch geometry, cyclic pitch geometry)10 6 Horizonal/Vertical mount orientation 11 7 Operate direction (Aileron, Elevator and Tail) 12 8 Servo(Swash and Tail) end point13 9 Cyclic pitch limit13 9 Adjust menu(Menu LEDs flashing)14 0 Swashplate cyclic center adjustment 14 1 Max roll(Ail and Ele) rate14 2 Max yaw rate 15 3 Tail – torque precompensation (RevoMIX)15 10 Firmware update16 11 Version history16 1 Standard receiver connection G31 Port Futaba Receiver Channel JR/Spektrum Receiver Channel Ail 1 AILE Ele 2 ELEV Rud 4 RUDD Gain 5 GEAR Pit 6 AUX1 Ax N/A N/A All input channel must be connected with signal except [Ax], otherwise G31 will stop at LED1! Do NOT connect the combo port [Gain, Pit, Ax] with power supply! 2 Connecting single-line receivers G31 can also connect t