斑马rfid打印机规格书.pdfVIP

ZPL II Commands for RFID Valid programming requires that printer instructions begin with the Start Format command (^XA) and finish with the End Format command (^XZ); they are the opening and closing brackets, respectivley, of a label format instruction. This subsection describes the RFID-related commands: ^WT – Write Tag ^RT – Read Tag ^RS – RFID Setup ^RI – RFID Get Tag ID ^RE – Enable/Disable Electronic Article Surveillance Bit 36 980476-001A ^WT – Write Tag The format for the ^WT instruction is: ^WTb,r,m,w,f,v where the parameters are: b = block number Default value: 0 Other values: 1 to n, where n is the maximum number of blocks for the tag This is the starting block number. If the user sends more than a block of data it will overflow into the next block. If the user overflows the block and subsequent blocks cause errors (write protects, beyond range, etc.), the write will be aborted, but blocks already written will not revert to original contents. It’s up to the user to ensure blocks aren’t accidentally overwritten. r = retries Default value: 0 Other values: 1 to 10, number of retries m = motion Default value: 0 (Feed label after writing) Other value: 1 (No Feed after writing, other ZPL may cause a feed) w = write protect