唐人街悬挑外架施工方案.docVIP

目 录 一、编制依据············································第3页 二、工程概况············································第3页 三、施工部署············································第3页 3.1 施工管理部署········································第3页 3.2 施工人员部署········································第4页 3.3 人员培训············································第4页 3.4 材料准备············································第4页 四、方案的选择··········································第5页 五、施工条件············································第5页 六、脚手架材质要求及准备································第6页 七、悬挑脚手架的搭设施工方案····························第6页 7.1 基本构造············································第6页 7.2 悬挑式钢管脚手架的技术措施··························第6-9页 八、外架验收············································第9页 九、安全防护措施········································第9页 9.1 电梯井洞口防护措施··································第9页 9.2 结构临边防护措施····································第9页 9.3 楼梯间防护措施······································第9页 9.4 楼板上洞口防护措施··································第9页 9.5 防雷电措施··········································第10页 十、外架搭设、拆除及使用安全注意事项··················第10页 十一、环保措施········································第11页 十二、安全平网搭设····································第11页 十四、悬挑架计算书····································第11-28页 十三、悬挑脚手架搭设体系平面图、立面图、剖面图、节点大杰图、各栋平面图··············第29-33页 悬挑脚手架施工方案 一、编制依据 1、《建筑施工计算手册》 2、《建筑施工手册》（第四版） 3、《建筑施工扣件式钢管脚手架安全技术规范》（JGJ 130-2001） 4、《建筑施工安全检查标准》（JGJ59—99） 5、《钢结构设计规范》（GB50017－2003） 6、《混凝土结构设计规范》（GB50010-2002） 7、本工程施工组织设计 二、工程概况 我公司承建的贵港市唐人街工程项目，地下为一层，地上一～三层为群楼，四层为架空层，五层以上为A、B、C、D栋主楼标准层，其中A栋30层（至构架顶共102m）、B栋26层（至构架顶共90m）、C栋16层（至构架顶共59.6m）、D栋20层（至构架顶共72m），总建筑面积约为96000㎡，总工期为680天。地下一层层高为4.22m；群楼一层层高为6.8m；二、三层层高为4.2m；四层架空层层高为3.9m，A、B、C、D栋五层以上标准层层高为3m。本工程裙楼大致呈“长方”形， 1～11轴长85.2 m，A轴～V轴长129.7 m；主楼A栋1－1～1－22轴长32.9 m，1－A轴～1－K轴长25.1 m、B栋2－1～2－17轴长51.8 m，2－A轴～2－M轴长20.2 m、C栋3－1～1/3－20轴长20.5 m，3－A轴～3－S轴长46.4 m、D栋4－1～1/4－34轴长52.4 m，4－A轴～4－U轴长29.1 m。 三、施工部署 3.1 施工管理部署 安全生产、文明施工是企业生存与发展的前提条件，是达到无伤亡事故的必然保障，也是我项目部争创“广西区安全文明工地”的根本要求。由于建筑脚手架