贝尔2G 无线参数详解.doc

贝尔2G无线参数详解 CELL参数详解 Cell Description：小区信息描述参数 Cell Name：Location Name：PLMN Name: Own PLMN BCCH Channel：Static SDCCH：Dynamic SDCCH：Traffic Channel：NCC Permitted：NCC Permitted (OMCR)Definition：Indicates which NCC values the MS considers as belonging to the network。 Spec reference：System information management Coding rule： Coded over 8 bits. each bit corresponds to a NCC value: MSB corresponds to NCC = 7, LSB。corresponds to NCC = 0. For each bit:0= NCC not permitted, 1= NCC permitted。 External comment： The value depends on configuration. The default value indicated here is for implementation purposes。 Internal comment：This parameter was previously named: “PLMN_permitted”。 Definition： This flag indicates to the MS if it reports a HANDOVER FAILURE in case of out of range timing Spec reference：External channel changes。 Coding rule：0→Out of range timing advance is ignored；1→ Out of range timing advance triggers a Handover。 Minvalue：0；Maxvalue：255；Defvalue：0。CodedMin：0；CodedMax：255；CodedDef：0。Unit：None。 BCCH_FREQ：BCCH_FREQ (OMCR) 67Definition：Indicates the frequency used as BCCH. Spec reference：Handover Preparation. Mandatory rule：In a cell where FREQUENCY_RANGE = “EGSM” or “EGSM-DCS1800”, the BCCH ARFCN belonging to the G1 band may be selected by the operator, only if. Recommended rule：EGSM_RR_ALLOC_STRATEGY0, and, for the concentric cells, only in the outer zone.These restrictions do not apply to external cells. Internal comment：The ARFCN of the G1 band are in the range {975, 976, …, 1023, 0}.For an own cell, the BCCH frequency is deduced from the radio TS description. Minvalue：0；Maxvalue：1023；Defvalue：None。CodedMin：0；CodedMax：1023；CodedDef：None。Unit：None。 TSC：TSC (OMCR)Definition：Training Sequence Code for any (packet) channel except for BCCH, CCCH and CBCH. Spec reference：Radio link establishment. Coding rule：coded over 3 bits. External comment：Default value depends on configuration. The value indicated here is for imp