num系统参数培训资料3.pptVIP

MAXIMUM AXIS TRAVERSE RATES The values are expressed in mm/min for linear axes and deg/min for rotary axes. Notes: Maximum value: (decimal) The values are always expressed in mm/min, whatever can be the CNC increment (or in deg/min). The real speed of the axis may momentarily overshoot P30. The value of P30 can be read in E970xx (read-only parameters). PARAMETRABLE RANGE POTENTIOMETER Notes: The values must be positive or null. The highest value is 255. The lowest value is 0. The maximum value must be higher than the minimum value. 100% must be contained in the range. If incoherence ? value forced by default 0% min - 120% max for feed potentiometer. JOG SPEEDS The values are expressed in mm/min for linear axes and deg/min for rotary axes. The speeds can be modulated by the feed potentiometer. MAXIMUM PERMISSIBLE ACCELERATION For each axis, 2 accelerations must be entered. They can be equal. SERVO-CONTROLLED AND INTERPOLATED AXES SERVO-CONTROLLED AND INTERPOLATED AXES It is possible to modify the controlled status of axes by programming (in MDI or Continuous mode) with E910xx parameters. SERVO-CONTROLLED AND INTERPOLATED AXES DIRECTION OF AXIS THE SPEED REFERENCE SERVO-SYSTEM LOOP GAIN COEFFICIENT (KVAR) MAXIMUM FOLLOWING ERROR Note: P23 is expressed in internal increments. Institut Schneider Formation Institut Schneider Formation Institut Schneider Formation NUM 1060 - DC1 906/F / 5 - * All rights reserved Automation Business / Num P30 Type 4 No. of words Unsigned decimal 32 Configuration of the maximum speed for each axis. Word N0 N16 Axis 0 Axis 16 15 N15 31 N31 14 N14 30 N30 13 N13 29 N29 12 N12 28 N28 11 N11 27 N27 10 N10 26 N26 9 N9 25 N25 8 N8 24 N24 7 N7 23 N23 6 N6 22 N22 5 N5 21 N21 4 N4 20 N20 3 N3 19 N19 2 N2 18 N18 1 N1 17 N17 P67 Type 5 No. of words Unsigned decimal 32 Used to modulate the feed rates between minimum and maximum range. Group 1 Word N0 N1 Min Max Group 2 Word N2 N3 Min Max Group 8 Word N14 N15 Min Max P31 Type 4