RN1133GQW规格书RICHNEX品牌标签.pdfVIP

RN1133 USB 2.0 ULPI Transceiver RN1133 product brief 1. General Description RN1133 is a high performance USB 2.0 transceiver chip which supports low speed (LS), full speed (FS) and high speed (HS) data rates. The interface to a LINK controller is via UTMI+ Low Pin Interface (ULPI). RN1133 also supports USB On-The-Go (OTG) mode which allows both Host and Peripheral operations. An up to 8KV HBM ESD protection circuit is integrated on the USB connection pins providing stronger ESD protection and reducing BOM at the same time. With the built-in 3.3V to 1.8V regulator and power on reset circuit, RN1133 is the best choice for low cost, high performance USB 2.0 OTG transceiver applications. 2. Features Complies with Universal Serial Bus Specification Rev. 2.0 Compatible with USB On-The-Go Supplement Rev. 1.3 USB-IF OTG Compliance Test certified. TID: 100000021 Complies with UTMI+ Low Pin Interface (ULPI) Rev. 1.1 Complies with ULPI 8 bit mode Supports ULPI 3/6 bit serial interface modes Supports the USB Host Negotiation Protocol (HNP) and Session Control Protocol (SRP) Supports USB FS pre-amble packets Supports Carkit Mode which routes UART signals thru USB pins Integrated 24MHz crystal oscillator allows both crystal and input clock operations Only requires a single 3.3V power supply with an integrated 3.3V to 1.8V LDO +/- 8kV ESD protection on DP, DM pins Integrated Power On Reset circuit Low power consumption and suspend current for portable applications Small footprint (5mm x 5mm) 32-pin QFN package RN1133 Product Brief Rev. 1.0 Confidential Page 1